Modify Selection
- Hazard prevention and control:
- Gob gas vent holes
- or
- Horizontal boreholes
Home Links
Results 11 - 20 of 23
-
1/1/1990 - Reports of InvestigationsThe Bureau of Mines preproduction wireless survey system (WSS) and its performance during an in-mine test are discussed in this report. The WSS was developed to reduce downhole surveying time in order to increase the efficiency of drilling long horizont...
-
1/1/1987 - Reports of InvestigationsGob holes are routinely used by the mining industry to vent methane from gobs and to prevent it from entering the mine ventilation system. In some cases, flows from gob holes are measured by centering an anemometer on the end of a discharge pipe. These ...
-
1/1/1986 - Reports of InvestigationsThe Bureau of Mines conducted studies to compare the effectiveness of the cross-measure borehole system with that of surface gob holes on two successively mined retreating longwalls in the Lower Kittanning coalbed. Only the cross-measure system was in o...
-
1/1/1986 - Reports of InvestigationsAn investigation of the effectiveness of methane drainage in the lower Sunnyside coalbed at Kaiser Steel Corp. Sunnyside No. 1 Mine in Utah. Most previous attempts to drain methane gas using long horizontal holes were conducted in the eastern coal provi...
-
1/1/1986 - Information CircularsThe goal of this research was to evaluate the integrity of existing shutoff valves and actuators used under high-temperature conditions in the Bureau of Mines' horizontal borehole methane drainage pipeline system and to determine system improvements.
-
1/1/1982 - Reports of InvestigationsThe Bureau of Mines has developed several techniques for draining methane from coalbeds in advance of mining. Drilling long horizontal holes from an underground location is one such technique, which was successfully demonstrated in the Pittsburgh and Su...
-
1/1/1982 - Reports of InvestigationsThe Bureau of Mines conducted research to degasify a virgin block of coal in the Beckley coalbed using long horizontal holes drilled in an array from the bottom of a ventilation air shaft. Eight horizontal holes and an in situ pressure hole were drilled...
-
1/1/1981 - Reports of InvestigationsThe Bureau of Mines has completed an underground degasification project in which an underground piping system was used to transport methane from the coalbed to the surface. In a 10-month period four horizontal holes were drilled to an average depth of 1...
-
1/1/1978 - Reports of InvestigationsDiscusses research to determine the effectiveness of long holes in degasifying an area of the upper split of the lower Sunnyside coalbed at Kaiser SteelCompany Sunnyside No. 1 mine. These holes were drilled from the two outside entries of a section that...
-
1/1/1976 - Reports of InvestigationsMethane emission from two surface gob-degasification boreholes was measured by the Bureau of Mines. The investigation took place during mining of a 3,200-foot longwall panel in the Lower Kittanning coalbed in central Pennsylvania. The first hole was 500...
Home Links
Content source: National Institute for Occupational Safety and Health, Mining Program